Tuesday, August 18, 2015

Jeep 3rd Brake Light Install


During my aftermarket rear bumper install, I realized I needed a third brake light. Check Your state's 3rd brake light law. 


Maryland law states -- 
"Section 22-206(a)(1): Every motor vehicle registered in this State and sold as a new vehicle after June 1, 1967, shall be equipped with at least two stop lamps."   

I went with the Barricade Adjustable Brake Light Bracket with LED Light 👉 Read More  



Install Steps

This install was pretty simple once I figured out the wiring. First, I needed the factory wiring harness, which I had all ready removed from the old brake light.





With an Allen Wrench, I removed the LED light adjustable bracket from the mount. 




Then bolted it to the pre-drilled holes for the factory spare tire mount. 




Now it was time to wire up the LED light to the factory wiring harness.  I needed to cut the factory brake light wires at the plug and connect those wires to the LED wires. However, I was a little puzzled. The LED has three wires and the harness has too. 


The directions stated -- Connect the black factory wire to the white LED light wire and the white/orange factory wire to the red LED light wire. There was still the third black wire. I didn't know what to do with this wire. I was told to just secure it with heat shrink and leave it so that is what I did.



I'm told by a fellow Jeeper that this is a standard STT trailer light used with this application. That is because they are inexpensive, readily available, and mount easily with the grommet. These lights have a circuit for running lights and turn signal/stop. Hence the name STT - Stop Turn Tail.



You can attach these wires with butt connectors.  I decided to solder, heat shrink, and liquid tape them together. Just like I learned when I wired up my Raxion LED lights. 👉 Read More 

Once all the wires were connected, I inserted the LED 3rd brake light into the adjustable bracket with a firm push. Then attach the brake light bracket to the mount attached to the tailgate.




I had to get creative with the wires by running the wiring harness down the bracket to the hole in the tailgate. Then plugged the wires back into the brake lights. 






6 comments:

  1. Additionally, when you do get a Jeep, let me put a photograph and a story/portrayal of it on my site here:
    car dealerships near me

    ReplyDelete
  2. Incredible posting this is from you. I am really and truly thrilled to read this marvelous post. You've really impressed me today. I hope you'll continue to do so! https://krmlight.com/8-ft-led-bulbs/

    ReplyDelete
  3. AVOID A CAR ACCIDENT 7 The definition of the word accident is "an unexpected and unwanted event, a mishap unforeseen and without apparent cause." Though some accidents are in fact unavoidable, many accidents or collisions can be avoided by simply paying closer attention to three simple parts of your car. Brakes Though modern b best rated dot 3 brake fluid

    ReplyDelete
  4. The Wrangler's ground clearance is one of its greatest benefits and since you'll be so high up, you'll be able to easily see everything down the road. jaxcjdrwestside.com

    ReplyDelete
  5. The blog you've shared is wonderful because it has a wealth of knowledge that will be really useful to me. Thank you for sharing that information. Keep up the excellent work. Led Light Company in Dubai

    ReplyDelete
  6. Excellent knowledge, You are providing important knowledge. It is really helpful and factual information for us and everyone to increase knowledge. Continue sharing your data. Thank you. Read more info about us products in india

    ReplyDelete

Jeep's Plastic Side Steps

Take Them Off for Off-Roading The Jeep Wrangler's plastic side steps, usually on the Sahara model, serve a practical purpose in daily us...